surface mount ceramic chip capacitors x7r dielectric x7r/0402 - .012 f (123) - .10 f (104) @ 6.3; 10; 16 volts metric eia size max. size code code l - length w - width t - thickness b - bandwidth separation 1005 0402 1.0 (.04) .05 (.002) 0.5 (.02) .05 (.002) see table 2 0.20 (.008)-0.40 (.016) 0.3 (.012) table 1 dimensions - millimeters (inches) new product bulletin outline drawing f-9022a 4/05 table 2 - x7r - capacitance value extensions capacitance values (f) kemet part number capacitance tolerance thickness mm qty 7? reel qty 13? reel .012 c0402c123(1)(2)rac k,m 0.5 .05 10,000 50,000 .015 c0402c153(1)(2)rac k,m 0.5 .05 10,000 50,000 .018 c0402c183(1)(2)rac k,m 0.5 .05 10,000 50,000 .022 c0402c223(1)(2)rac k,m 0.5 .05 10,000 50,000 .027 c0402c273(1)(2)rac k,m 0.5 .05 10,000 50,000 .033 c0402c333(1)(2)rac k,m 0.5 .05 10,000 50,000 .039 c0402c393(1)(2)rac k,m 0.5 .05 10,000 50,000 .047 c0402c473(1)(2)rac k,m 0.5 .05 10,000 50,000 .056 c0402c563(1)(2)rac k,m 0.5 .05 10,000 50,000 .068 c0402c683(1)(2)rac k,m 0.5 .05 10,000 50,000 .082 c0402c823(1)(2)rac k,m 0.5 .05 10,000 50,000 .10 c0402c104(1)(2)rac k,m 0.5 .05 10,000 50,000 (1) to complete kemet part number, insert the alpha code for tolerance desired. k = 10%; m = 20% (2) to complete kemet part number, insert the numeric code for voltage desired. 9 = 6.3 volts; 8 = 10 volts and 4 = 16 volts.
? kemet electronics corporation ? p.o. box 5928 ? greenville, sc 29606 ? (864) 963-6300 ? www.kemet.com electrical parameters as detailed in the kemet surface mount catalog f3102 for x7r, with following specific requirements based on room temperature (25c) parameters: ? operating range: -55c to +125c, with no-bias capacitance shift limited to 15% over that range ? insulation resistance (ir) measured after 2 minutes at rated voltage @ 25c: limit is 500 megohm-microfarads ? capacitance and dissipation factor (df) measured at 1khz at 1.0vrms. df limit for 6.3 and 10 volts is 5.0%. df for 16 volt is 3.5%. soldering process the 0402 components are suitable for reflow soldering only. all parts incorporate the standard kemet barrier layer of pure nickel, with an overplate of pure tin to provide excellent solderability as well as resistance to leaching. marking these chips are supplied unmarked. in general, the information in the kemet surface mount catalog f3102 applies to these capacitors. the information in this bulletin supplements that in the catalog.
|